I have the solix 12 SI and while scanning the left side of the image is dark in the shallow water side. The right side is working good. I might add at one point looking at the screen it started working properly I don't understand how this could be. Any ideas on what might be causing this problem?
Post a picture of your transducer installation.
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
If your transducer is on the right side of the motor(starboard side) you might try trimming out your motor some and see if that helps. Bob
Originally Posted by bobcoy
This is what I have to do if I want really bright SI on the left side.
Try adjusting the SI sensitivity offset
Last edited by Capw; 02-26-2018 at 10:34 AM.
2017 Ranger Z520c "Blackout Edition"
2017 Mercury Optimax ProXS 250
HB Solix 12 G3 MSI+, Solix 12 G2 MSI+, Solix G2 MDI+, Solix 12 2d/gps, Ultrex Mega360, Mega Live
NRA Life Member
-Be sober, be vigilant; because your adversary the devil, as a roaring lion, walketh about, seeking whom he may devour-
I had one side of my image go dark on an onix unit ,it work fine for a while then went dark , so i knew it wasnt the install, call hb , there turn around time is very quick..
Make sure transducer is level
Reply With Quote