I have a 2017 Suzuki 140 four stroke. What options do I have for a transom saver? I seen the lock-n-haul, but other than that maybe a my wedge kit. Any suggestions. Thanks.
I have a 2017 Suzuki 140 four stroke. What options do I have for a transom saver? I seen the lock-n-haul, but other than that maybe a my wedge kit. Any suggestions. Thanks.
I am curious on the 250ss too
I use the one that runs from engine to trailer.
I ended up using the traditional transom saver as well. I tried the sliding block one for the Yamaha's, but due to the steering ram fittings, I'm not able to tilt it forward enough to slide it over the rods. I've also looked at the motor saver sticks made by TH Marine, but the sticks are either too long or would be pushed against the grease zerk fitting.
2018 Bass Cat Lynx w/Suzuki 250SS.
There is a device called " lock-n-haul. You have to send pictures of your transom mount, and motor bracket on outboard for them to tell you if it will fit...??? They say on their website it fits Suzuki....
IMG_20180222_188.jpg
2018 Bass Cat Lynx w/Suzuki 250SS.
Moto stop
The offshore Yamaha I believe is the one, but you can contact them, it's what I did. I really like mine. And yep it fits just fine.
http://www.moto-stops.com/products/y...oto-stop-2.php. This one I believe. The non sho Yamaha is the same shaft width and such for the saver to slide on.
I use the 2 sticks for my 250 ss. They have an arrow pointing to one end that says mercury and other end has arrow pointing to Yamaha. Obviously my engine is neither one of those brands but I put them on my trim/tilt rods (I believe that's what you call them) with mercury arrow facing "up" toward engine. They are just 2 hollow metal rods with black hard plastic ends. They probably have some type of name. They're maybe 8-10 inches long each. I also use something very similar to the link procrafokie posted to keep steering from going left and right during transport. Both very useful products.
I too use a moto stop.. Contact Mike at MotoStop, I believe mine is a Yamaha but fits my Suzy perfectly.
Bowhunter
2017 Alumacraft Competitor 205 Suzuki DF250, Suzuki 9.9 EFI Kicker, Garmin Network
I just searched around to figure out what mine are for my suzuki DF250ss. T and H Marine Motor Stik. A pair of them $31.
Moto stop just called me, and they said that the one for the Yamaha 2 stroke and Sho will fit my Suzuki 140. Distance between Center to center of tilt rods are 4-1/4", which is exactly what mine is, and 11/16" tilt rod diameter. The part number for the Moto stop is MS-y2x
Nice! I like my moto.
175 DF conventional.
I use the T H motor sticks. I had to notch one for a grease zert, if I remember right.
War Eagle Blackhawk 2170 - Suzuki 150, MG Xi5
Lowrance HDS 7" & 9" - Twin Talon 12' Anchors
My wedge is what I use on my 250ss