Went from an aluminium 19P to SS Laser II 21P. Lost some hole shot but gained about 3-4mph top end. I understand there are trades offs, but is there anything I can do to gain the hole shot back?
Went from an aluminium 19P to SS Laser II 21P. Lost some hole shot but gained about 3-4mph top end. I understand there are trades offs, but is there anything I can do to gain the hole shot back?
Try to find a 20" pitch prop you can borrow to split the difference.
The laser II should have PVS holes and plugs in it. If it does you may need to increase plug sizes in the prop.
You might try a 19" Laser II. You pick up speed just going to stainless.
Venting the prop can help. If this is the laser II with the rectangular slots, someone will need to drill PVS holes in it for adjustable venting.
Even though you picked up speed, make sure your motor is running near the top of the RPM range, so you are not lugging the motor.
If it will turn that many rpm's at WOT it needs more venting on take off and that's what the PVS system was invented for so if it has PVS holes increase the size of the plug holes. Your trying to reach 3500-4000 rpm's at take off.
Any idea how many rpm's your turning at break over? You still have a plug to pull. What motor do you have?
Break over = take off in your case
Are you still running two open one hole with a large plug? Your trying to get your take off rpm's in the range of 3500-4000 so I'd say you have too much venting now. Does the prop blow out any now.
John Clark — Findlay, Ohio
I sent my 21P Laser II to Mark Croxton and he added cup. What a difference that made. My PVS holes are wide open. Picked up speed and hole shot was much better.
2019 Skeeter ZX225
Did you buy any large ones or just small, medium and solid? Leave the large plug in and put one medium in an open hole.