Twist Knob Switches 2000 201DC Cobra

[Irving-NorCal]

I'm looking for twist knob switches in 2 way and 3 way lighted. My panel is to the right side of operator. The panel needs to be replaced also. Helm dash needs replacing also. Any suggestions appreciated. Irving

[TomM]

There's a sticky at the top of this forum that may help.

Tom

[RiverSnake]

This what I used to replace mine,

https://www.overtons.com/search/sier...otary%20switch

There is another part needed for illumination ,can't find the part number right now , I post it as soon as I can.

[RiverSnake]

Finally found where I ordered my knobs and illumination modules,
2 position knobs MP78710
2 position illumination module MP78870
3 position knobs MP78820 & MP78800
3 position illumination module MP78820


Hope this helps..

[Irving-NorCal]

Thanks. I ordered parts. Appreciate your help.

[Irving-NorCal]

Thanks for all the help. Ordered the Illumination Modules that sit atop the switches and installed them, all back up and working now. I also ordered Blue LED Lights (10) 11MM 112 volt to install around inside edge. My buddy did it to his Skeeter and it's awesome in the dark. Going to wire off my Dimmer switch for my gauges so I can adjust the amount of light. I'll start a new thread for that project. Again Thanks for a the help.