Sleeve for Ultrex cable/wiring

[Bassintoo]

Here's mine

[4Kboater]

I wish there a product like this for the TM shaft to cover the ducer wire.

[TroyBoy30]

kinda like this?

[4Kboater]

kinda like this?

Yes, that would work as long as it didn't slide up and down. Just something other than my current setup of tie wraps that slide out of place or you have to cinched them down hard causing a possible cable cut. I also sometimes have grass that gets caught between the ducer cable and shaft.

Ideally a neopene cover like the troll saver would be great for me.

[ISUOFIA]

kinda like this?

Tease! I'll bite...what is that and where do I get it?

[22RangerZ520R]

[TroyBoy30]

its a sheath that i got from a user here. i'm not sure the name now or where you can get one. we cut mine into small pieces or i'd send it to you

[4Kboater]

Here's the setup I used with electrcial spiral wrap. I no longer worry about the tie wraps falling down and the ducer wire has a bit more protection. I bought the spiral wrap from the borg for $2.98

[j archer]

I bought some of this off ebay, I cut it to the correct length but where it gets cut if frays, any tricks there

[4Kboater]

I bought some of this off ebay, I cut it to the correct length but where it gets cut if frays, any tricks there

By saying "it frays", do you mean is starts to unravel like if you cut a rod sock? The stuff I used is solid material (polyethylene) a few wraps of good electrical tape will hold the ends down.

[j archer]

Yes unravel

[Cam692]

I've used the braided rod sleeves on wiring coming out of my counsel. Get some liquid electrical tape and coat the last inch or so of the ends to keep it from unraveling.