I have 6 bolts in my jackplate right now, I need to go up another click or two, is it safe to run with just 4(2 on each side) I believe I did on my 2004 21 XDC but I can't remember
I have 6 bolts in my jackplate right now, I need to go up another click or two, is it safe to run with just 4(2 on each side) I believe I did on my 2004 21 XDC but I can't remember
I would move the motor up on the jack
plate. Its probably bolted in the middle of the 5 holes. Each hole is about 3/4"
What He Said!!! ^^^
If the engine is already up on the plate, you need to call Steve as you may have an outdated outer plate! The newer design is taller and has a cross brace close to the top!
20XDC Bullet/Modified Merc 260
295TF Charger/Merc 225X-Sold
20' Contender Pickle Fork/Merc EFI Bridgeport-Sold
18' Stratus with Sommerford Tunnel Vee Hull/2.4 EFI Merc High Perf-Sold
Freedom 240DLX Toon/Merc 115
10' Cougar Cub/Merc 25 on the Bottle
18" Homebuilt Tunnel/.021 OS Max Outboard on 50% Nitro with a Pipe
What he said. ^^^ Mine had the plate that was for below the pad. I called Steve and he made new plates for getting above and added 2" of setback. Steve is the man to call.
I have the new magnum plate, it's in the upper part of the plate, I my not be far off of where I need to be