Results 1 to 6 of 6
  1. 02-16-2018, 04:52 AM #1
    ctbassnut
    ctbassnut is offline
    Member
    Join Date
    Feb 2008
    Location
    Durham
    Posts
    37

    07 Z20 jackplate?

    I'd like to add a jackplate to my boat and unsure what size to get seeing as my boat has a built in off set transom. Boat has a 225 yammie on it. Anyone run this set up with a jackplate that could recommend size I should get. Never had a jackplate before so I'm green to this stuff and appreciate the advise. Thanks guys.
    Reply With Quote Reply With Quote
  2. ericm
    ericm is offline
    Member
    Join Date
    Feb 2006
    Location
    Wheeling, WV
    Posts
    1,996
    #2 02-16-2018, 06:46 AM
    The Z20 needs a 10" plate. Hydraulic if you've got the coin.
    2006 Ranger Z20 / 225HP Merc Pro XS
    Reply With Quote Reply With Quote
  3. jt c
    jt c is offline
    Member
    Join Date
    Jul 2012
    Location
    south carolina
    Posts
    973
    #3 02-16-2018, 07:14 AM
    I had a 10in with my z20 with a pro xs motor
    Reply With Quote Reply With Quote
  4. jg522
    jg522 is offline
    Member
    Join Date
    May 2007
    Location
    Paulina, La.
    Posts
    431
    #4 02-16-2018, 07:17 AM
    Mine came from the factory with a 10’’ Bob’s hydraulic.
    2007 RANGER Z20 / 225 ProXS
    Reply With Quote Reply With Quote
  5. ctbassnut
    ctbassnut is offline
    Member
    Join Date
    Feb 2008
    Location
    Durham
    Posts
    37
    #5 02-16-2018, 10:38 AM
    thank you guys 10 in it is then
    Reply With Quote Reply With Quote
  6. brenlen
    brenlen is offline
    Member
    Join Date
    Jul 2004
    Location
    Corte Madera, CA
    Posts
    501
    #6 02-16-2018, 10:52 AM
    Mine came from factory with a 10" jackplate. Ranger recommends it for those original Z boats. Start with it being 3.5 inches below pad, unless you go hydraulic.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »