Jack plate

[Bass N Beer]

I just had Steve at Hydro Dynamics replace mine. It’s pretty sweet.

[pmgoffjr]

This question comes up again and again. Here's where it breaks down:
The only people who will recommend something besides a rapid jack are the people who've never had one. So if you don't know...you just don't know.

[86 inches]

Ok, I’ll say it... too bad they don’t make a hydraulic plate.

[pmgoffjr]

They just came out with one.

[LOSTTEXAN]

Heaven forbid someone perhaps puts a Bob's Hydraulic on their Champion

[Dan21XRS]

Took the factory installed Slidemaster off and installed a Bob Action Jac... Couldn't be happier... Had a Rapid Jack on my 2002 Bullet, good plate but I wouldn't say it's better or worse than any other manual plate... Dan

[ChampioNman]

Took the factory installed Slidemaster off and installed a Bob Action Jac... Couldn't be happier... Had a Rapid Jack on my 2002 Bullet, good plate but I wouldn't say it's better or worse than any other manual plate... Dan

But it is the easiest to adjust. 1 click 1/4" up.

[Tx Champ]

But it is the easiest to adjust. 1 click 1/4" up.

And you're pulling from both sides, not just the center like my Slidemaster. Lot easier to keep it straight. Until now, Bob's was the hydraulic plate if you wanted one. If Steve is building them now, I would give him a hard look.