where are you guys mounting your point 1 gps antennas on the ranger boats? I have a 2011 z520 thanks
where are you guys mounting your point 1 gps antennas on the ranger boats? I have a 2011 z520 thanks
Mine is mounted to the underside of the rear battery compartment's composite lid on a 2009 z520.
" If you are going to be stupid, you have got to be tough!"
Mine is exactly the same as basscfo and works like a champ!
2013 Z118 w/Merc 150 4S
"Never argue with an idiot; He will beat you to death with stupidity"
2012 Ranger Z521, 250 ProXS
thanks guys
another question I thought point 1 needed clear line of site to the satellite? does mounting under the rear compartment door effect the line of site? thanks,
Last edited by cfm56doc; 02-12-2018 at 08:00 AM.
2013 Z118 w/Merc 150 4S
Mine works fine under the rear lid, never had any issues. Like mentioned above it is the closest location I could get to the transducer mounted under the step.
2012 Ranger Z521, 250 ProXS
Ordered a mount from WackyRiggers in Salisbury NC. mounts with 2 sided tape. around $25
http://www.wackyriggers.com/
under products and custom accessories
Tommy Coleman
2016 Ranger Z518C
Fiberglass does not block GPS sat signal much at all. However Aluminum (or anything metal for that matter) will block the GPS signals.
When mounting the point-1 primary focus should be to avoid Magnetic interference, not getting as close to the transducer as possible.
Anything magnetic near by will cause issues with the heading sensor in the point-1. Check and double check for magnetic interference and the temporarily mount the P-1 before drilling any holes, and take for a test run.
simple question. how do you test for magnetic interference? thanks
You can use the compass APP on an iPhone or find a cheap mechanical compass. Put the compass in the spot you have in mind for mounting, run the engine or the motor and see if the needle goes crazy. If it does, try a different spot cuzz you're getting some interference.
2017 Phoenix 819
2016 200ProXS, s/n 2B359849, Mod 1200P73BD