So i have a ton of arigs i dont use with no blades i tend to only throw ones with blaes where can i get the stuff to add blades? I have the blades just need a way to attach
So i have a ton of arigs i dont use with no blades i tend to only throw ones with blaes where can i get the stuff to add blades? I have the blades just need a way to attach
No way to just add them without the hardware already on the rig, without it looking junky. You'll have clip the ends, slide on the components and then re-bend the loops at the end. Look over various bladed rigs and use the method you prefer.
Phoenix 721 - Yamaha SHO 250 - 8' Blades
Yea im aware i need to clip the ends off which is no biggie but where can i get the components?
You do not need to clip the ends. Use copper wire to make a loop.arigblade.jpg
Make another wrap between that and the end and super glue in place.
Good idea! So that loop the swivel is connected to is the same wire thats on each side?
You can look at Barlows, Hagens , lureparts, many other will have the stirrup, swivel and blades.
2002 Pro Craft 200 Super Pro- 2005 200 Mercury Optimax, Retired
Empty Nester- Proud Grandfather 5-30-2014-Boy-Aiden, 8-2-2017-Boy-Calen
Can also use underspin heads as the jig heads as well. There are times when that really works good
~~1995 Gambler~~
Mercury 250 ProXS
Bobs 10" AJ
Dual Power Poles
2-HB 1199's HB 1158 HB 597 in dash
Ultrex 112
"Runs like a cheetah... with his @$$ on fire"
You need these, from Barlows.
https://www.barlowstackle.com/Clevr-...vis-P3348.aspx
Just add and recrimp. I use them to change the front blades on spinnerbaits.
Use a pin or hook in the holes and open up the clevis, install, then recrimp over the wire. They come closed. I wish they came open.
anyone know of what I can use to stop the clevis from sliding?
Saltwater steel leader crimp.
This is what I use. https://www.barlowstackle.com/Metal-...cers-P848.aspx