Ultrex on a Z7?

[einsteins]

What did you do with the Steering control cable coming out of the front of the pedal?

[Rjack81]

I’ll take a picture when I get home, and you can see how it fits.

[Rjack81]

I can't seem to get the picture attached. I tried from my phone yesterday and my work computer today, but the pedal fits tight at the front of the tray.

[SoonerFan]

I can't seem to get the picture attached. I tried from my phone yesterday and my work computer today, but the pedal fits tight at the front of the tray.

I'd like to see those pics if possible. You can either e=mail or text them to me. I can PM you the numbers if you want.

[Rjack81]

I’d be happy to send them. I sent you a pm

[SoonerFan]

I’d be happy to send them. I sent you a pm

[SoonerFan]

I don't know. I think I may still have to go with cutting some of the back side of the tray out. I play with it and see what works.

Thanks for sending the pic.

[Rjack81]

Glad to help. You have to do what works best for you.

[einsteins]

Hard to tell but is that cable sleeve bent upward at a hard angle?

Thanks for sharing...

[Rjack81]

Slightly...yes.

[bosshawg79]

I have a Z-7 and just installed my custom tray from Fishon to accommodate the Ultrex. It was the same design done for all of the Z-8s sporting new trays. It was perfect and Mjgarret is right, Dawson at Fishon will make it whatever depth you like. It did take a few weeks to get the tray as the powder coater was backed up but all in all, it was a good decision for me. I would highly recommend Fishon Fabrications. I will post some pics of my new setup when I get a chance.

how did you do it?

[SoonerFan]

http://www.bbcboards.net/showthread....842&highlight=

Here is how I expanded the corners of the TM tray on my 591 without installing a whole new aftermarket tray. I still haven't got around to replacing that ratty looking carpet.

[remaly181]

how did you do it?

I measured for the new tray, trimmed the carpet, then cut the fiberglass to accommodate the new tray. Depending on your tool selection, it is about a half hour to a an hour job.