how long does it have to sit in the mold before you can take it out?
how long does it have to sit in the mold before you can take it out?
That mostly depends on how hot the resin was. If the glass is hard to the touch and you can't really bend an edge you are most likely good to go. Did you wax the mold? apply Gelcoat first? You do NOT want to remove it if it is soft at all. I have resins that will be hard in about 10 minutes and others that will take a day minimum.
6 hours is just fine with most glass and resin mixtures the chargers dit overnight or about 12 hours before they are pulled
I guess they allowed Robert to come up for air again. LOL.
[QUOTE=Sports1;9104551]I guess they allowed Robert to come up for air again. LOL.[/
As long as Robert gets that 198 ready for production to start in March, he is our Hero.
I know if it is pulled too soon it looks wavy.
I got nothin
I got nothin
from start to finish on a hull its paint time glass time stringer,boxes,floor,and foam it takes 4 days a deck takes a bit over two days
and for those who want to know im doing all i can to get the 198 done but wont give a date on when sorry
Robert do you paint and lay the hull, then pull it the next morning form the mold?
it takes two days to paint a hull,then you first skin it ,then you second skin it and put the roveing in,them you put in the transom,stringer,floor,and foam boxes then its pulled after foam is put in
I got nothin
no secrets there lol besides im sure ranger and vexus have enough on there minds and dont worrie much about little ole me
Last edited by Hickory Legend; 02-22-2018 at 08:13 PM.
Ranger better listen they need help for sure