Last edited by cbailey; 01-31-2018 at 06:42 AM.
above pic is a HDS 9 carbon touch in the dash.
elbow storage compartment tray for radio with storage
rear grab handles with stroker laser cut in them with base vent plate. youll have to excuse the dirt. i wasnt through with boat when i took pics
Awesome work as always Chris!
I hope that is some kind of plastic protection film on the gunnel, that's what it looks like at least.
2021 Phoenix 920 Elite / SHO 250
Bullet 21XD / 250 XB (Gone to a great home in LA)
"There is no such thing as a bad day fishing!"
not new to stroker but a 300xs powerhead i did with a madefi 15" mid section, factory 280 15" clamp assy, 300X carbon fiber cowling, side ram steering
2021 Phoenix 920 Elite / SHO 250
Bullet 21XD / 250 XB (Gone to a great home in LA)
"There is no such thing as a bad day fishing!"
its all powdercoating. i took the opportunity while case was empty to add an extra touch for customer
That is all awesome well done.
LeaLea
Looks great!!!!! were does the radio go?? and is that davids old boat?
Last edited by bassworm1; 01-31-2018 at 09:56 AM.
Did you enjoy working on a yellow and purple boat? LOL
looks great
it was alot of work but yes i did. im still not done though. im pulling the 300xs powerhead and dropping on a zero hour 300x powerhead. 2004 model thats been in a warehouse since mother merc built it. still going to add a deck extension with 2 compartment lids along with a bunch more stuff.
Looks great, Chris you do some very nice work.
Damn nice work CB. Looking incredible.
Mr StrokerDee :thumb
I always loved that boat and its a runner too!! You do awesome work for sure!! in the bottom pic of the motor the cavation plate and mid looks a little off is that the angle of pic?