ONIX 10 SI cross touch. Sheared it clean off. Looks like 11 wires. Are all wires used? Do i need to solder all wires? Could make a big bulge. Is it important to reshield the pairs?
Looked at hummingbird website and couldn't find a wiring diagram
ONIX 10 SI cross touch. Sheared it clean off. Looks like 11 wires. Are all wires used? Do i need to solder all wires? Could make a big bulge. Is it important to reshield the pairs?
Looked at hummingbird website and couldn't find a wiring diagram
Last edited by wannafishmo; 01-13-2018 at 01:10 AM.
I believe you will have to replace the entire transducer because the integrity of the wiring has been compromised.
It can be soldered, but it’s not simple. You stagger the wire lengths so the joints aren’t aligned. Each wire needs heat shrink and then the whole works needs sealed. I’d recommend you get a friend who’s familiar with electronics to do it.
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.
I'm going to try. Sounds like a new skill to work on. I'll let you know..
Be certain no water can invade the splices, could smoke your unit. This is the reason HB will not tell you how to do it. Also without maintaining connection and insulation from each other and the shields must be maintained to prevent interference. Good Luck! Bob