I have a 24 Raker original that has 7/16 exhaust holes that blows out on holeshot with 2 anglers & i have to feather it until it catches & goes on. Coming out with 3 is nearly impossible even though i rarely have 3 in the boat. Also if you slow down to stop then decide to go on you have to come to a stop & start over. I was thinking of epoxying all three of them up & redrilling to 5/16 to reduce the blowout. Essentially it would basicly be like doing away with one hole which should help getting out of the hole. Am i right in my thinking? Also when redrilling would you go with 5/16 or 1/4 inch? Thanks