Kepp up with pics man looks amazing!
Kepp up with pics man looks amazing!
Brent Christian,
Ashland, Kentucky
93 Bullet 20xrd 1993 Yamaha Prov 150 1 3/4 below pad 27p Shooter 12imch Jackplate
1993 Ranger 397v 20 Foot Fish And Ski 235 Evinrude (Sold)
1989 Gemini 189GT 18 foot 200 Johnson Gt looper, 10in Jackplate, Hotfoot, 81 mph gps (Sold)
1978 Checkmate BassMate "Oldie But Goldie" 88 spl Johnson. (Sold)
Ok fellas thanks for the compliments! I’ve been making some more progress. I was on hold waiting on pedestals/bases from Llebroc but they expedited the shipping to get me going quicker.
Moved the base back approx. 8 inches to make things more ergonomic
I had these backing plates leftover from an old jack. Enlarged center hole and voila: under deck support plate
ive installed the Lund cockpit flooring but the contact cement is taking forever to dry! Pics later
Lund cockpit flooring
Left channel for drainage
Finally the pad is all stuck
Rubberized spray coated this wet locker
Carpet entire front casting deck is next
Enjoying the process as the pieces begin to fall into place
Going to use the hell outta this recessed tray !
So much work to get to this point
thanks for checking out the post
Awesome Job!
Looking good!
Post #34, the boat is sitting on floor Jack's? Can you elaborate?
I'm in the process of acquiring a '87 Skeeter Strada. Will be a cap off job. I'm looking through threads , getting ideas.
Thank you for all the photos, they really help!
Thank you very much!
Close to finishing front deck
Still have to glue the rearward facing portion of console carpet and there’s a few seams left to weave
Looking great! The step/storage bin and passenger foot ramp details turned out awesome - really updates the old boat to a modern look.
Anymore updates on this build?
Boat is getting closer to being outboard ready. I’m waiting on the fuel tank repair as it had sprung a tiny leak in floor of tank. I’ve finished installing the pumps, livewell valve, plumbing, thru hull fittings, aerators.
Drain plug eliminator is pretty nifty.
Jackplate ready to go on transom.
6 gauge power supply to TM installed
Getting there slowly but surely.
Nice work! Very clean.
I’ve got a v160 myself. Love what you are doing!!!
Anymore updates?