I know it was said that the Ultrex 52" mount was 4 inches longer than the 45" but i would like to know the actual length of each mount. I'm currently running a 50" MG X5 and will be changing to the Ultrex soon.
I know it was said that the Ultrex 52" mount was 4 inches longer than the 45" but i would like to know the actual length of each mount. I'm currently running a 50" MG X5 and will be changing to the Ultrex soon.
I'll get you a measurement of the 45" base.
BBC Sponsor since 2006: (870) 773-3474
Mon - Thrs 8am - 5pm Central
Friday 8am-12pm
Garmin Certified Dealer and Installers: Call us for all your Garmin Electronics needs!
ASC for: Garmin, Lowrance, Minnkota, Humminbird, and Powerpole.
[SIGPIC] http://www.jonestrollingmotor.com
[/SIGPIC]
26"...that is just the mount base. I had a MG before and fits perfect on my bullet.
Is that 26" measurement including the plastic nose or just the metal section of the base?
I have a question: Where are you measuring to and from to determine shaft length? Exposed shaft only? I am not near my motor right now to check, but wondered.
Shaft length is measure from the top of the motor to the split of the head.(where the top of the coover attaches to the bottom of the cover) the length will be more than 45"
Thank you, Bradrodfish!
Taken from under the mount, from the plastic point to the end of the metal base: 28 inches for the 52. The plastic sides are 2 inches more.