Friends, I have a Nitro Z7 with single axle trailer. Since the axle shaft is tubular, I know not to place my jack under the shaft due to safety reasons. What are some better options for placing my jack when forced to change a flat? Thanks
Friends, I have a Nitro Z7 with single axle trailer. Since the axle shaft is tubular, I know not to place my jack under the shaft due to safety reasons. What are some better options for placing my jack when forced to change a flat? Thanks
Though many recommend against it, I jack on the end of the axle. Conventional springs I go right where the axle is bolted. It’s the strongest spot to lift. Just make sure you aren’t crimping the axle. I use a notched block of wood on my boat, and a piece of pipe with an ID about the same as the OD of the axle on my camper and cattle trailer.
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.