Took my prop off and noticed there was no spacer between thrust washer and propeller, #6 in diagram. Went online to look at videos and none of the videos had them either. Is there supposed to be a washer in the assembly for a VMax T1 SHO prop?
Took my prop off and noticed there was no spacer between thrust washer and propeller, #6 in diagram. Went online to look at videos and none of the videos had them either. Is there supposed to be a washer in the assembly for a VMax T1 SHO prop?
Last edited by Bonanza; 12-29-2017 at 07:12 AM.
The spacer is probably in the prop hub, it's a two piece washer and it doesn't always come out of the prop.
Is this it (stuck) ?
Just talked to Mark C, said this washer is purposefully pressed into the prop and does not come out. So much for the schematic diagram.
I removed mine and run a one piece set up instead of the two piece.Originally Posted by Bonanza
Are you running it with just the thrust washer and no spacer?
2017 Phoenix 721 ProXp w/250 YamahaSHO
Yup it replaces the 2 piece setup...my understanding is the 2 piece was the cause of some Props eating into the lower unit.
What is the part number for the new 1 piece Thrust washer?
Interested in this too
2017 Phoenix 721 ProXp w/250 YamahaSHO
I will get it when I pull the prop next.
I think this may be a part for the long shaft engines, 25". Just a thought.
Reply With Quote