-
1983 Johnson 70hp blown seal?
Ive kept my boat outside for 15yrs but this Fall it was unusually warm here and I used it into mid-November. But it got cold a couple days after and has stayed cold.
Today I noticed that some lower end oil had seeped out around the prop.
Im assuming there was water in it that froze, expanded and blew the seal?
1983 Johnson 70hp 3cyl
-
It could be residue exhaust oil. Did you take out the top plug to see I it was over full, or the bottom plug to drain and check for water?
-
I had put new in June, but I can try that tmrw.
-
SC Club Moderator
Pull the prop off and check for fishing line on the prop shaft.
-
Pulled the prop today and there were a few yards of braid wrapped in it
-
SC Club Moderator
That will do it. You'll need to pull the rear bearing carrier and replace the seals.
-
-
Do you guys have a preferred vendor for this seal?
-
SC Club Moderator
I only use Evinrude products. I rarely if ever use after market parts. Support your local dealer if possible.