Here is how I did mine to keep things less cluttered.
Here is how I did mine to keep things less cluttered.
Eddie
2017 Phoenix 920 Pro XP Mercury 250 Pro XS
. Simple to install, they charge around $500 to $1000 to 8nstall them around here so I did it myself. I did run my hoses in a mesh sleeve from Cable Ties and More along with shrink tube. Look as good or better than the local boat shop would have done. Pm me if you have any questions.
Hey if anyone wants to help with the install I'll have beer and pizza.
I've got some guys in the club that will help me with the install but its the first time for all of us. I looked today and I found where I can move my onboard charger to.
I also looked at some pics in a google search and saw where folks mounted the pump brackets on the back wall of the bilge...is it ok for the pumps to be suspended like that? Seems like you would want a sturdy bottom to support them and they won't bounce around...
Family is everything!!! Fishing is a close second
2010 TR-18 Pro w/150 OptiMax & Dual 8' Blades
If I was closer sure! Pay for air fare? lol
Eddie
2017 Phoenix 920 Pro XP Mercury 250 Pro XS
Im not sure id want my pumps to be suspended. As far as the install iv installed 2 sets by myself. If i can do it anyone can
Once you do it bud you will wonder why you were so concerned. Its very very simple..
Will I need to drill holes in my jackplate? I have a pro hi-jacker. My jackplate is as high up as it can go.
Last edited by lilbuddy; 01-09-2018 at 08:04 AM. Reason: jackplate
Family is everything!!! Fishing is a close second
2010 TR-18 Pro w/150 OptiMax & Dual 8' Blades
no holes to drill! bolt up using your 2 lower bolts, 10 min install of brackets to jackplate.
Family is everything!!! Fishing is a close second
2010 TR-18 Pro w/150 OptiMax & Dual 8' Blades
You guys have been awesome so Im going to continue with my questions.
Do you guys put a wood block or something under the motor? I know you would do one bracket at a time. Will the bolts on the other side be enough to support the motor while you get the bracket sturdy?
I plan on installing the poles this Saturday. I'm trying to do as much as I can now in the way of prep etc.
Thanks y'all
Family is everything!!! Fishing is a close second
2010 TR-18 Pro w/150 OptiMax & Dual 8' Blades
Yea I'd support some how so not all the pressure is on the adjusting bolt and the other side.
Eddie
2017 Phoenix 920 Pro XP Mercury 250 Pro XS
if you do one side at a time then no need for the block. All the weight is on the screw when you adjust so not really a big deal. not like your leaving it for any length of time.
Thanks again.
Family is everything!!! Fishing is a close second
2010 TR-18 Pro w/150 OptiMax & Dual 8' Blades
Post pics when done
Family is everything!!! Fishing is a close second
2010 TR-18 Pro w/150 OptiMax & Dual 8' Blades
One suggestion if you have not thought of it. I would wire in a power switch one of each pole. The pump controls pulls juice all the time and if you leave it set up with out a charger on all the time the batteries will be drained.
you should wire in a battery cut off switch yes, however not 1 for each pole as mentioned above. 1 battery cut off with both poles going to it.
Get the power switch. I have to add that.
2017 Phoenix 819
2016 200ProXS, s/n 2B359849, Mod 1200P73BD