As the title states, I am installing a Blue Seas 5025 Fuse Block and want to run my plans by you guys. I plan to install the fuse block in my driver side rod box. I plan to use 10ga marine wire from my master power cutoff and negative in the battery compartment to power and provide ground for the fuse panel. I then plan to use 12 or 14 ga marine wire to connect my Sonar/GPS units, HB 360 switch, nmea power and LSS-1 module to the fuse panel. I plan to use ring terminals (w/heat shrink) for all end connections and butt splices (covered with heat shrink) to extend wiring as required to reach the fuse panel. Comments / Suggestions??
Thanks