How do you remove the inlet screen to get to the lube drain screw?
How do you remove the inlet screen to get to the lube drain screw?
Pool 10
Remove the screw holding the lower inlet screen on the nose of the case and then you can access the drain screw. Make sure you replace the seal when done.
https://www.etecownersgroup.com/post...change-7770759
Thanks championman, found it and got it changed. I know evinrude recommends changing at 5 years but it sure looked pretty dirty with only 80 hours.
Pool 10
Not being a smart ass but when was the last time you changed the rear end fluid in your tow vehicle? We check outboards because they are submerged an if their seals are compromised, the result is water intrusion. I would imagine the first replacement would show some use on it. Any shavings or burned smell?
Good point with the comparison! No shavings or burnt smell, everything looks good. Just a little surprised at how dirty it was at 80 hours, especially since half of them were probably off plane.
Pool 10
Yeah it was a poor analogy, I was really referring to the discoloration and meaning most folks never check or replace their differentials. If you did there would certainly be discoloration. Seeing the OP didn't post up a picture of what he was seeing it was a general comment.
The exhaust does not "dump" on top of the gears. It is surrounded by wall of water as it travels down from the powerhead to the prophub inside a separate exhaust chamber which has cooling water sprayed into it also. The exhaust goes through the cavity in the gearcase behind the gears and oil. The gears and oil are also submerged which transfers heat from the gearhousing into the surrounding water.
-----
A Technical troubleshooter possessing more tools than talent !
John Clark — Findlay, Ohio