LED light wiring question

[Bonanza]

Thinking of mounting some oznium leds in the rubrail. For nav lights I know to hook them to the existing female bow nav light recepticle. For the rubrail black lights, how do you run the wires on the port side to the starboard rod locker fuse bus?

[DREWTICK]

you can take the wires to the bow and back down the other side of remove the lid covering the gas tank and go straight across

[Kanbass]

you can take the wires to the bow and back down the other side of remove the lid covering the gas tank and go straight across

What lights are those?

[DREWTICK]

What lights are those?

oznium 6mm

[Kanbass]

oznium 6mm

Thanks

[sdendy]

Drew are those with lens or without? Black or stainless Steel? Can you give a little more detail on these. Did you just drill through the rub rail and wire together into the front light?

[DREWTICK]

Drew are those with lens or without? Black or stainless Steel? Can you give a little more detail on these. Did you just drill through the rub rail and wire together into the front light?

this in on my Buddy's 920, they are 6mm black aluminium, drill the 1/8" holes first for the wire and then the 6mm just deep enough for the light, its very close to going all the way through anyway. fill the holes with silicone, insert the lights and let setup, another option is drill the 6mm holes, remove the 7/16 tubing and put the nut on the back of the tubing but not tighten enough to flatten then the silicone on the threads will keep the nut on, his has been on for 2 years and no issues with them coming out of getting loose.

oh no lens on these

[sdendy]

Thanks Drew I like this better than cutting the rub rail and inserting the LED Strips I may have to try this