I have a 2011 21xrd and found a 1" hole that was drilled into floor from previous owner and a thin layer of fiberglass put over it. The boat had the carpet removed and bedliner installed and I removed the bedliner and put carpet back in it. I just got around to removing the bedliner material from the floor board today and when I was pulling it up a thin layer of fiberglass pulled up with it and there was a 1" hole from a hole saw. I could see the foam in the hole and stuck my finger inside and the foam is wet. Not sure where water got to it but can water get to the foam if the previous owner left the boat outside uncovered and left plug in it and rained enough to get to the foam. Anyone know it that's possible in a Bullet. Any suggestions?