I've read and followed a lot of advice from this forum on winterizing my Skeeter with a HPDI 200 Yamaha. The only part I can't figure out is how to drain the water out of the speedo tube and water pressure tube to the gauges (if required).
I've read and followed a lot of advice from this forum on winterizing my Skeeter with a HPDI 200 Yamaha. The only part I can't figure out is how to drain the water out of the speedo tube and water pressure tube to the gauges (if required).
just disconnect them from the back of the gauge.
Just another beer drinker with a fishing problem.
And blow air through it. I put a tee in mine just below the gauge so I can get to it without issue. CJ And yes it is required. Seen a lot of boats with junk water pressure gauges AND speed gauges from this.
2002 X19 200HP OX66 HO Vmax,HPDI lower, it lives, thanks Hydro Tec.
I also put a note on my steering wheel to remind me to hook it back up before first trip in spring. Don't need wet feet to start the day.
1998 Tr-21, 2001 Yamaha 225 OX66
Hook everything back up after you blow it out. Ready to go in spring. CJ
2002 X19 200HP OX66 HO Vmax,HPDI lower, it lives, thanks Hydro Tec.
Don't blow out the gauge by pressurizing it with an air nozzle, they only are designed for about 30 PSI not 125. If I had mine hooked up I'd block the line off and fish without it in winter.
Your cooling water gauge is 30 the speedo is 70+. I always have it on regulated air. I guess I thought that went without saying, sorry.
2002 X19 200HP OX66 HO Vmax,HPDI lower, it lives, thanks Hydro Tec.
The line should be 1/4". Find a pneumatic T fitting and a plug. Pull the plug in winter works great.
1998 Tr-21, 2001 Yamaha 225 OX66
I disconnected the speedo line and nothing came out. It looked pretty corroded in there. Guess that's why it's not working!!