Just replaced the pulleys on a mg tour. How much tension should be on the cables.
Just replaced the pulleys on a mg tour. How much tension should be on the cables.
the foot pedal should be "tight" enough to keep the slack out of the footpedal when you change directions. Any more than that and you risk damaging the bearings.
BBC Sponsor since 2006: (870) 773-3474
Mon - Thrs 8am - 5pm Central
Friday 8am-12pm
Garmin Certified Dealer and Installers: Call us for all your Garmin Electronics needs!
ASC for: Garmin, Lowrance, Minnkota, Humminbird, and Powerpole.
[SIGPIC] http://www.jonestrollingmotor.com
[/SIGPIC]
The cable is snug but when you change directions it does show slack. But just as soon as you change directions then it’s right.
When you change directions, should be no slack. If there is, the cables could roll off the pulleys.
BBC Sponsor since 2006: (870) 773-3474
Mon - Thrs 8am - 5pm Central
Friday 8am-12pm
Garmin Certified Dealer and Installers: Call us for all your Garmin Electronics needs!
ASC for: Garmin, Lowrance, Minnkota, Humminbird, and Powerpole.
[SIGPIC] http://www.jonestrollingmotor.com
[/SIGPIC]
Ok thanks
Reply With Quote