I have an 1199 at the bow and have recently paired it with an Ultrex using the Ethernet port. In order to do that, I had to disconnect from the unit at the console. My question is: Can I have both a connection with the Ultrex and a link to the unit at the console. If so, what port do I use and how do I do it?
Everything connects to the Ethernet hub, do you have the 5 port Ethernet hub? If so you might just need another cable.
Need the AS ETH 5PXG and a total of 3 Ethernet cables.
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
Thanks Wayne, I was afraid that would be the only solution but I am not sure it is worth paying another 265.00 to link my units. I think I will put my waypoints on an SD card and just transfer them. I have just purchased an Ultrex motor and am tapped out at the moment.
Reply With Quote