Page 2 of 2 FirstFirst 12
Results 21 to 24 of 24
  1. SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    71,248
    #21
    See this? Loosen the Phillips and move the roller to the timing hash mark on the cam.

  2. Member
    Join Date
    Oct 2014
    Location
    chillicothe ohio
    Posts
    98
    #22
    it is as far right as the adjustment will allow set at .008 I cant move it far enough to catch the line what gets me is push the key in supply more fuel clears up like to much air awhile back had a loose reed gasket was back firing out of the carb

  3. SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    71,248
    #23
    When you installed the intakes did you coat the bolts with black RTV? That seals the intakes from sucking in air. You may want to check the reed blocks again to make sure they are tight. Use blue loctite on the screws that hold them to the intake.

  4. Member
    Join Date
    Oct 2014
    Location
    chillicothe ohio
    Posts
    98
    #24
    thank you so much for the help keep you posted on what I find will pull it apart this winter going to try and get some fishing in before winter thanks again

Page 2 of 2 FirstFirst 12