1B972754. Somehow I have broken the ground wire on the outside lower unit. Does this need to be replaced? I thought I had read this ground wire was needed if the boat motor is stored in the water all the time? Maybe I'm dreaming too.
1B972754. Somehow I have broken the ground wire on the outside lower unit. Does this need to be replaced? I thought I had read this ground wire was needed if the boat motor is stored in the water all the time? Maybe I'm dreaming too.
2021 Phoenix 21PHX
If it's damaged I'd replace it... They put it there for a reason... Dan
I'd guess it's more of a bonding wire since it appears to be stainless steel.
2021 Phoenix 21PHX
Helps ground the trim sensor as well.
ttt
Asked and answered, so why the ttt?
Don't you have to remove the motor mount to replace it? That's a big job, power head has to come off.
No.
_______
Phil
'09 Hewescraft ProV
'09 150 Optimax
Following since I have the same issue.
There are actually two (2) ground wires- one is hidden UNDER the port side lower mount cover, the other attaches under the NUT at the front of the Swivel YOKE (and via a 6mm bolt, to the swivel bracket).
If the outer/visible ground is the one broken- it can be replaced WITHOUT removing the mount or driveshaft housing (simply hold the bolt that is hidden under the cover, remove the nut, replace the ground strap, reinstall and retorque the nut, then reinstall the cover over the mount).
Note: This outer ground strap is often damaged by a worn engine support socket (large metal socket with a rubber insert that wears away pretty quickly)... often caused by running the trim down excessively once unit is installed. Once the engine rests firmly on the support, there is no need to continue running "down".
If it's the one hidden under the mount... that's a different story.
Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
Still consider myself a "Marine Apprentice" after 47 years (learn something new every day).
Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor
Does anyone have the part # for this grounding wire?
a swivel ez motor support will cut them,the pockets are to deep on a swivel ez motor support
_______
Phil
'09 Hewescraft ProV
'09 150 Optimax
Found it, 88238A10, thanks.