Hey for you guys running the 201 pro xl with a 225 pro xs what numbers are you getting and what's your best setup?
Hey for you guys running the 201 pro xl with a 225 pro xs what numbers are you getting and what's your best setup?
Stratos 201 Pro Elite, Evinrude 200 Etec H.O., Minn Kota, Humminbird
My buddy ran a 25 Trophy on his 201/225 Merc. It ran very good with that setup. Good all around combination.
I have a 201PE with a 225efi. 24 trophy plus works well for me.
i would try a 24p bravo 1 with 8 vent holes--works really good on my boat with twin talons-- i would also call marks propellors and ask him for advice so you dont waste money on bad choices--or try mike lohn on set up/props board as he knows almost as much as mark does about props
2022 z519 cup 225 merc 4s ser # 3B210484. 2--hds12 live units. 2 poles, atlas plate, ghost, hamby's, active target, merc digital gauges
2002 basscat pantera 3 (dad bought new) sold 8-2-22
2000 stratos 20 ss (bought new) 200 hp Rude ficht great boat/motor sold 11-21
pulled by a 2500HD Denali
proud dad of an ARMY Captain
MAGA
ASE/GM Master tech before tools
Have an 08 running a 25 three blade fury 6 inch manual plate at around 31/4. Have ran72 but 70 in our hot Oklahoma weather is more common. Great holeshot
Stratos 201 Pro Elite, Evinrude 200 Etec H.O., Minn Kota, Humminbird
I would say a 26 p Tempest plus @ 2.75 below pad .....most of the 26 p where off bad new out of the box ,may need to be worked .
And a Bravo 1 XS 25 p also would be a good choice with a 250 Pro XS
Thinking more about the above post . I just brought a Bravo 1 Xs 25p from a fellow that was running it on his 2017 Ranger Z521 250 Sporty XS @ 69.8 gps .
The Ranger is bigger the Stratos 201 pro ....i would go with a 25.5 or 26 P Bravo 1 with a 250 motor .
2022 z519 cup 225 merc 4s ser # 3B210484. 2--hds12 live units. 2 poles, atlas plate, ghost, hamby's, active target, merc digital gauges
2002 basscat pantera 3 (dad bought new) sold 8-2-22
2000 stratos 20 ss (bought new) 200 hp Rude ficht great boat/motor sold 11-21
pulled by a 2500HD Denali
proud dad of an ARMY Captain
MAGA
ASE/GM Master tech before tools
I don't know him personally , i was just chatting with him on the board he was selling the prop . You may know him .He went by BlackStroker , here. He sold the boat and bought a new Ranger Z521 . He is in Wisconsin. He was chatting with the guy's over there after the Ranger dealer meeting .
If it was my boat id be running a hydromotive QIV-X OB.
Stratos 201 Pro Elite, Evinrude 200 Etec H.O., Minn Kota, Humminbird
Well finally got to run my boat and with the 25p fury and 3/4 tank of gas and all my tackle shop in the boat. It ran 70.7 @ 5600 rpms. Holeshot is really quick even with dual 12ft talons
3 blade or 4?
ok so new numbers after running it yesterday, @ 5700 rpms I hit 72.2 with same as the post on 09/03. This is with a 25p fury 3 blade. I'm thinking that I can go up 1/2" or so on the plate and try a 26p. What you guys think?
Stratos 201 Pro Elite, Evinrude 200 Etec H.O., Minn Kota, Humminbird
You still have some rpm's left. Just raise it 1/2" and see how it runs before swapping props.
Yup, get that between 5850-6050 and hit that sweet spot. 1/2" should get you there, but Furys usually like to be run a hair deeper than other props.