Results 1 to 4 of 4
  1. 08-03-2017, 09:01 AM #1
    boldencg
    boldencg is offline
    Member
    Join Date
    Aug 2017
    Location
    Maryland
    Posts
    1

    Question How to Bleed Power Pole HPU

    I just purchased a 2016 Triton and I am going to remove my poles from my 2001 Triton to the new boat. Anyone know how to bleed the HPU's. Thanks

    Chris
    Reply With Quote Reply With Quote
  2. Hydrilla Gear
    Hydrilla Gear is offline
    BBC SPONSOR
    Join Date
    Jun 2004
    Location
    South Florida
    Posts
    6,073
    #2 08-03-2017, 06:09 PM
    Lower the Power Pole to about 1" off the garage floor. Manually push the pole closed by hand. This will remove most of the fluid and PSI on the lines.

    Watch your fingers.
    Reply With Quote Reply With Quote
  3. KandKKustomz
    KandKKustomz is offline
    BBC SPONSOR/ Shallow Water Anchors Moderator
    Join Date
    Apr 2015
    Location
    New York
    Posts
    10,941
    #3 08-03-2017, 06:21 PM
    Quote Originally Posted by Hydrilla Gear View Post
    Lower the Power Pole to about 1" off the garage floor. Manually push the pole closed by hand. This will remove most of the fluid and PSI on the lines.

    Watch your fingers.


    Reply With Quote Reply With Quote
  4. 06 SB
    06 SB is offline
    Member 06 SB's Avatar
    Join Date
    Feb 2012
    Location
    West Point Lake, GA
    Posts
    11,008
    #4 08-03-2017, 07:57 PM
    Yup. You have to give a pretty good amount of pressure but works!

    USN Retired
    2020 Basscat Caracal
    2020 Mercury 225 ProXS 4s


    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »