-
370 hull ranger prop height setup
where do you get the 3 1/2 inches on a 370 ranger hull? is it from the bottom of the hull are from the lower step???
-
Always measure from the lowest part of the hull normally under the drain plug and if your motor is bolted to the transom and you don't have a jack plate you can't run that high usually 4 1/4" under is where you would run.
-
tks, got a jack plate, shade tree mechanic said my moter was too high so he adjusted, just measured an im now 6 1/2 from pad to center shaft, lost 4mph and 400 rpm, let me get my 3/4 tools out..
-
http://www.bbcboards.net/showthread.php?t=62660 This shows you how to measure just make sure everything is level