Results 1 to 8 of 8
  1. #1
    Member tav's Avatar
    Join Date
    Sep 2013
    Location
    CT
    Posts
    1,354

    foot pedal trays

    been lookin around for some used bass boats , see a lot with foot trays.
    not to crazy about them. can you remove the tray and some how make
    make it flat . just wondering if it can be done.

  2. Member fishnfireman's Avatar
    Join Date
    Apr 2005
    Location
    Amarillo
    Posts
    12,432
    #2
    Attached Images Attached Images

  3. Banned
    Join Date
    Oct 2013
    Location
    GA / SC
    Posts
    11,283
    #3
    Just leave the tray in and install an insert of some type to fill the hole and bring the area back flush with the rest of the deck. You might or the next person down the line might change their minds and want the tray again.

  4. Member
    Join Date
    Apr 2012
    Location
    Weaubleau MO
    Posts
    1,473
    #4

    2013 Ranger Z518 cover up.

    Leave trey installed and just finish off deck over it. You can always take out cover and still have trey.
    Attached Images Attached Images

  5. Member
    Join Date
    Mar 2013
    Location
    mt holly,nc
    Posts
    238
    #5
    im curious as to why you dont like the foot tray?knee problems used to limit my fishing time,when i finally got my 1st tray several years ago,it was like getting a cortisone shot without the needle!

  6. Member tav's Avatar
    Join Date
    Sep 2013
    Location
    CT
    Posts
    1,354
    #6
    kinda partial on the MK POWER V2 foot pedal , put it anywhere on the deck. just like the open floor plan myself that's all.

  7. Member
    Join Date
    Apr 2017
    Location
    Colleyville, TX
    Posts
    575
    #7
    I just covered my tray with a piece of 1/8" aluminum plate and some 3M non-skid. Used the existing footwell screws to attach the plate. My Ulterra foot pedal is loosely attached to the new flat plate with a large piece of velcro.
    Joe B

    2017 Tracker PT 190 TX
    2017 Mercury 115 Pro XS
    Mercury Spitfire X7 19” prop
    51 mph @ 6240 rpms (RPMs from Vessel View Mobile) : full fuel tank and fishing load by myself
    4.2 second Hole Shot (measured using Vessel View Mobile)
    Engine mounted in 3rd hole
    Minn Kota Ulterra-Link w/built in MDI 80 lb thrust 60” shaft
    Humminbird Helix 12si Gen1 chirp on console
    Humminbird Helix 15si Gen4 cho on bow
    Humminbird Mega360

    Dotline two step transom boarding ladder
    Tracker trailer bow boarding step

  8. Member
    Join Date
    Mar 2013
    Location
    mt holly,nc
    Posts
    238
    #8
    Quote Originally Posted by tav View Post
    kinda partial on the MK POWER V2 foot pedal , put it anywhere on the deck. just like the open floor plan myself that's all.
    gotcha,makes sense with that t motor petal.i had one on my cc boat nice to be able to slide it around the deck.