Does anyone know where I might buy one of these sockets for gear case drain plug removal?
Does anyone know where I might buy one of these sockets for gear case drain plug removal?
never seen one ,might try 3.0L section though, that's where the pros hang out
.................................................. ...the scariest thing in life is the unknown ...................................
I just use a MILD tap with my manual impact screwdriver. Works everytime.
I just use a big ol' flat blade screwdriver. Seems of have worked just fine over the years. Now, if I were changing 5 or 6 LU's a day I might need a special tool.
Don't worry Ma'am....
I'm only here for the Bass.
same as rocket
.................................................. ...the scariest thing in life is the unknown ...................................
Check with Snap On tools. They make a lot of specialty tools but they're proud of their stuff. I know they make a short "marine" screwdriver especially for those screws.
https://store.snapon.com/Marine-Plug...r-P760267.aspx
On my 1995 Mariner MagIII I bought an Evinrude drain plug. (Not sure if it'll work on a Yamaha) It has an Allen type fitting instead of a slot. As above, a slight tap or two will help loosen up the drain and vent plugs...BF
I send a show on the tube with one of them sockets.
Hollow ground screwdriver that fully fits the slot will work every time.
_______
Phil
'09 Hewescraft ProV
'09 150 Optimax
I just use a big screwdriver....