Well folks I have mine installed and tested on the water. I watched multiple videos, thanks to those who took the time to do them. However, in the videos I had to pause them and try to figure out little things like where to run the cables etc. This is a 45" 112v iPilot Link unit.
I have a Phoenix 721 and replaced a Motorguide Tour 109. I run a Humminbird 1199 up front with an HDSI transducer and a Hydrowave. I covered the transducer cable on the side of the trolling motor as with the prop stored out it rubs when stowing the trolling motor. I like it better as the head does not sit out as far.
For those who ask, I was able to pick up two holes from the Motorguide and drilled 4 new ones.
Here they are, I hope these help the other DIYer's! Holler if you have any questions.
2017-06-26 10.13.39.jpg2017-06-26 10.13.51.jpg2017-06-26 10.14.00.jpg2017-06-26 10.13.30.jpg2017-06-26 10.15.02.jpg2017-06-26 10.15.52.jpg2017-06-26 10.16.17.jpg