Had a change to get a hold of three pristine 4600 reels. I cannot find anywhere on the reels where the ratios are located. One is a 4600C1, and the other two are 4600C4. Can someone tell me? Thanks.
Had a change to get a hold of three pristine 4600 reels. I cannot find anywhere on the reels where the ratios are located. One is a 4600C1, and the other two are 4600C4. Can someone tell me? Thanks.
1997 STRATOS 285 PE EVINRUDE INTRUDER 175
Not sure but put a piece of tape on the spool and count the rotations per handle turn and you'll have your gear ratio.
If it's a new 4600 C4 that is blue it has a 6.3:1 and retrieves 30 inches of line. I can't even find any 4600 C1 anywhere. But they do have a 4600 C3 and it's 5.3:1 at 25 inches per turn. Hope this helps
These reels are 30+ years old. thanks for the info.
1997 STRATOS 285 PE EVINRUDE INTRUDER 175
[QUOTE=drake322;8511492]These reels are 30+ years old. thanks for the info.[/QU.
I'll keep looking, but as of now I can't find anything on the reels going back that for.
Last edited by BrentR; 06-22-2017 at 01:36 PM.
turn the handle straight up to 12,put a small mark on top of the spool then turn the handle one complete turn and count the times the the spool goes around and that the ratio
Thanks.
1997 STRATOS 285 PE EVINRUDE INTRUDER 175
4600c4 were 6.3. The oldest 4600 were 4.7, later were 5.3. The 5.3 usually says high speed on it somehwhere