What's the best way to get to the mounting bolts for the trolling motor bracket on a Phoenix 618? I removed the panel in the middle of the front shroud and there is a round hole there, but looks tough to get your arm in there. Has to be better and easier access. Thanks.
smaller arm or cut a bigger hole
Drewcraft Specializes in Lithium Batteries and Chargers, We carry all Brands of Trolling Motors and Graphs, Minnkota, Lowrance, Garmin, Motorguide
910-722-0001 call or text
info@drewcraft.com
That's the only way to access the mounting bolts is thru that round hole, it's tight so watch your arm on the fiberglass, just take your time you can get to them.
Brett Carnright could get both of his arms through that hole at the same time.
Last edited by billspence; 06-20-2017 at 08:51 PM. Reason: The Midnight Grapher can do it!!!!
"I am going to Eufala to just idle around"
-Haus
***NEW*** 2023 Ford F150 XLT Super Crew 2.7L Ecoboost FX4 cause I am such a baller.
2021 Phoenix 721/ Mercury 250 ProXS 4s with a bent ass trailer
HDS16 live- Solix15 : Console
HDS16 live W/AT - Garmin 126 W/ lvs34 - Solix12/ 360 : Bow
Dual 10' Blades/ Lowrance Ghost/ Bobs Hydraulic Plate
225ah cranking / 100ah trolling. Ionic/Relion lithium
Instagram @brettcarnright. Teamviewer: bCarnrite@33
I just swapped out a Motorguide to an Ultrex on my 721, I got in and out with no problem. Only piece of advice I have is cover the edges with duct tape, kind of tough on the arm!
2021 Phoenix 819 - Mercury 200 Pro XS - Ser No 2B779353
Ultrex/Humminbird Helix 12 SI Mega/Helix 10 Mega DI/Mega 360
Garmin 1022 with LVS34
I just replaced TM on my 920. It was not that difficult if you use a ratcheting wrench. The closer in bolts were more of A pain that the ones in the nose/
I've installed and taken off 4 times now. Its not that bad. I did enlarge my hole with a dremel though.
Jason
2015 Phoenix 919 225 ProXs
Reply With Quote
