-
2000 X21 jack plate prop shaft height?
2000 X21 with 200 Xri , prop shaft is currently 6" below pad. Currently have a Tempest plus 25p on it and also have a 24 pitch Trophy plus...running about 54mph at 5200rpm wot....any ideas? Thanks!
-
Go to the lake.
Make sure it's got a typical load in the boat.
I'd start at 4" and then run it, raise it 1/4" at a time, and go until you lose lift, speed or water pressure. Then YOU"LL know exactly where it needs to be. Nobody can know here, because no two rigs are exactly identical.
Pat Goff
Two degrees from center
of nowhere.
Smithwick TX.
-
Ten four...that's what I was looking for a starting point....Thanks! Any opinion on which prop I should work with?
-
Pat Goff
Two degrees from center
of nowhere.
Smithwick TX.