If putting a light strip under the port side rub rail, what would be the best route to run the wiring to hook it to the Accessory switch?
If putting a light strip under the port side rub rail, what would be the best route to run the wiring to hook it to the Accessory switch?
2016 Phoenix 618 Pro / Mercury 175 Pro XS
depends on where you are putting the lights, if near the middle of the boat its easier to go back to the battery compartment and across, personally I remove the seats and the gas tank cover and go straight across but everyone doesn't enjoy taking the boat apart as much as me
Last edited by DREWTICK; 06-16-2017 at 11:44 AM.
Drewcraft Specializes in Lithium Batteries and Chargers, We carry all Brands of Trolling Motors and Graphs, Minnkota, Lowrance, Garmin, Motorguide
910-722-0001 call or text
info@drewcraft.com
I ran mine through the tackle compartment.
Jason
2015 Phoenix 919 225 ProXs
I've had my seats and tank cover off, it wasn't bad to do.
The strip I have if I decide to use this one is 16ft long, so I could go from the back. (This is just for night fishing)
2016 Phoenix 618 Pro / Mercury 175 Pro XS
16ft should put you close to the rear of the boat. You should be able to go right across the bilge compartment.