Results 1 to 4 of 4
  1. 06-15-2017, 09:05 PM #1
    jrbritt
    jrbritt is offline
    Banned
    Join Date
    Dec 2008
    Location
    orlando
    Posts
    1,040

    How to plug water inlets so you can raise your motor above the pad if needed.

    water level.I pluged the holes with epoxy from the allen screw up. on both sides . take wax paper an tape to outside of screens, then fill inside holes with the epoxy when dry , pull wax paper off. I run motor 3/4 to 1 inch ABOVE THE PAD. WATER PRESSURE AT 6,000 RPMS 15 TO 16 PSI OF WATER PRESSURE'

    Last edited by jrbritt; 11-19-2017 at 09:30 PM.
    Reply With Quote Reply With Quote
  2. jrbritt
    jrbritt is offline
    Banned
    Join Date
    Dec 2008
    Location
    orlando
    Posts
    1,040
    #2 06-15-2017, 09:07 PM
    Today, 09:58 PM
    I have had a few people ask me if I stripped down the lower unit to bare aluminum. the answer is YES. I bead blasted it. same as sand blasting just not as hard on the aluminum. then painted the screen silver to match the aluminum.... feel free to ask ., if you want to know more.
    Reply With Quote Reply With Quote
  3. bassworm1
    bassworm1 is offline
    Member
    Join Date
    Jan 2006
    Location
    Cowan Tn.
    Posts
    5,031
    #3 06-20-2017, 10:18 AM
    That looks good!!!!!
    Reply With Quote Reply With Quote
  4. T-Bob
    T-Bob is offline
    Member T-Bob's Avatar
    Join Date
    Jul 2006
    Location
    Thibodaux La
    Posts
    2,149
    #4 06-20-2017, 01:39 PM
    Great idea JR....I like it
    Xpress X19/200SHO
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »