-
2011 Z118 150 PRO XS SETUP
OK 2011 z118 ranger with pro xs 150 6"OR 8" NOT sure slide master 23p tempest plus only getting 53mph 5400 rpms
Last edited by johnrt; 06-13-2017 at 10:49 AM.
-
Looks like your prop could use a refresh/repair. How many rpm's have you lost since it was new and did you put new plugs and a fuel filter in it this year.
-
no new plugs or fuel filter just got boat last fall
-
should i get new plugs and filter??? whos a good guy to send prop into for a refresh
-
Send your prop to Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176. Board member and sponsor.
-
Did you buy from a dealer or private? Your low on rpm's and it could be your too low prop to pad and not getting wide open throttle.
Last edited by mdtritn21; 06-13-2017 at 04:07 PM.
-
PRIVATE im gonna check the prop to pad tonight and post where its at thanks
-
Find a local Mercury dealer and have it put on the computer to check the throttle setting to make sure it's getting WOT. Prop to pad needs to be 3 1/2" and up.
-
update
prop to pad is in the 4" to 4-1/2" range
-
should i move it to around 3-1/2"???
-
Did you measure it like this? http://www.bbcboards.net/showthread.php?t=62660 Raise it to 3 1/2"
-
YES I DID but didnt use level more of an eyeball test getting it level then measured
-
It's hard to do it without a level
-
Got the level out... Prop to pad is 3 1/2" should I get prop worked to start??