PP Foot Switch Locations

[Michael49]

Ordered the PP Foot Switches ..... ( separate up & down buttons )
I have a recessed trolling motor pedal.

Was curious the location and arrangement of buttons if anyone has any pictures of your install.
I am "right footed"

[baptistbass]

This is how I did mine

[Spidergrub]

Same way that I did mine except reversed with the down on the right side of the pedal

[Whiteboat]

I have mine side by side in upper right because I needed to hide mark where old switch was.

If I was to do it again, I would put one on each side of TM pedal about mid way up

[bigbass225]

I step on em too much on the deck... so I put em up on the glass part

[fishin couillon]

Have the same switches.....had both on one side and didnt like it that way cause i was always crossing feet/legs and figured i'd end up in the water sooner or later so i put one on each side of TM pedal....alot easier to work.....

[KandKKustomz]

Have my personal ones on either side of recess.

[Somata]

I like mine on the same side, but with my BCB I was able to mount them pretty far forward in the recessed tray. I built a little riser for them so they're just below the level of the deck, and harder to accidentally hit. For me having them both on the right side works well. I switch the foot I use on the trolling motor, but lean toward using my right foot more, and it's easy to lift off of the trolling pedal and hit the switches. Whatever you go with, just give a lot of thought to how you use your deck. I tend to stay pretty far out on the nose, so installed them with that in mind.


https://www.instagram.com/p/BFi_xSZh...sorbeard&hl=en