-
Bow mount install?
I'm wondering if someone could gimme a step by step on installing a bow unit and how they attached the trolling motor transducer. Just don't wanna mess anything up lol
-
-
-
Where did you run the power to? My graph now is set up on the acc switch up front so I'm guessing that's where it connects?
-
to a dedicated blue sea fuse panel that is directly connected to the battery with 6 gauge wire
-
Sorry, can we start over? I was trying to see what lures you had tied up in the 1st pic! ;)
-
Member
Don't worry Ma'am....
I'm only here for the Bass.
-
Bringer Of The 'Bird
It is recommended that you criss-cross in a figure eight the extra cable instead of coiling the cable, this helps reduce potential interference issues.
Robert
Newaygo CTY, MI
Helix12MSI G2N v1.84/Helix10MSI G2N v1.84/Helix10MDI G2N v1.84/ASGPSHSx2/iPilotLinkv2.15/2.04RC-1+2/
-
Moderator
huh, I swear I read to coil the extra in the bird book
-
Member
Figure 8 for sure with a SI or DI unit. I don't remember it mattering so much with 2D sonars. Most of my extra transducer cable got wrapped around a ferrite ring.
Don't worry Ma'am....
I'm only here for the Bass.