Throttle handle removal/cover - ETEC

[Soardo]

Hi all,

Repowered with an ETEC and had a hotfoot installed. I want to remove the throttle handle and put an end cap on the throttle control area so I have less clutter in the cockpit. I can always replace the handle down the road if I want to go back to it.

Is there any way to do this and have it cosmetically look decent? Just remove the handle and re-use the existing trim/cover? I haven't taken one of these apart before....

Thanks,

-G

[mdtritn21]

Is it a G2 or an E-TEC? ETEC needs a shifter doesn't it where the G2 is electronic

[Soardo]

Good point. It's not a G2 so I can't really remove it then...