E225FHLSRM.
I have looked through my service manual and cannot find any spec for compression on this motor. I realize that each gauge reads a little different and that the cyls should be less than 10% difference.
So I have two questions:
1. What is a good compression number.
2. Using a leak down test what would be the largest number you would consider good.
Best Regards and Thanks
Nailer
2000 STRATOS 20SS EXTREME
2011 EVINRUDE ETEC 250 HO
HELIX 10 AND 12 SI
10' BLADES
ULTREX/ I PILOT LINK
HUMMINBIRD 360
Please!
2000 STRATOS 20SS EXTREME
2011 EVINRUDE ETEC 250 HO
HELIX 10 AND 12 SI
10' BLADES
ULTREX/ I PILOT LINK
HUMMINBIRD 360
add for one is sale section by dealer says all test at 90 psi like that is a good number? seems low to me 110 or so seems better
2022 z519 cup 225 merc 4s ser # 3B210484. 2--hds12 live units. 2 poles, atlas plate, ghost, hamby's, active target, merc digital gauges
2002 basscat pantera 3 (dad bought new) sold 8-2-22
2000 stratos 20 ss (bought new) 200 hp Rude ficht great boat/motor sold 11-21
pulled by a 2500HD Denali
proud dad of an ARMY Captain
MAGA
ASE/GM Master tech before tools
I saw that ad and thought the same thing but it is not the same motor as I am asking about. I am sure there has to be a baseline where the compression is deemed to be acceptable or where you need to run from it.
2000 STRATOS 20SS EXTREME
2011 EVINRUDE ETEC 250 HO
HELIX 10 AND 12 SI
10' BLADES
ULTREX/ I PILOT LINK
HUMMINBIRD 360
110 to 120 would be good # for that engine.
Dan Burnette - Marietta, GA
Triton 18TRX - 200 HO G2
Brand new I had 130 on mine. After 1800 hours I have 120 give or take 2-3 in a few cylinders. Make sure you run the engine to operating temps first like the manual says before testing. If I test mine cold the numbers are lower.
Formerly Gottwins (member since 2006)
Compression numbers are not posted in any manual.
Have 130 on all 6 after 500 hours.
2005 206
BRP 225 H.O. (E225DHLSOF)
Fury 4 24p @ 5,750 fully loaded
Reply With Quote