I'm looking for a good easy cheap idea to hold my cull floats to the lid of my live well. mine came with a suction cup holder that wont stay in place, fall off after a few mins.
thank you
I'm looking for a good easy cheap idea to hold my cull floats to the lid of my live well. mine came with a suction cup holder that wont stay in place, fall off after a few mins.
thank you
silicone the suction cup to the lid?
2004 Ranger 519VX
Yamaha VMAX 200HP OX66
use plastic corner bead for drywall and 3m 2sided tape. works great.
My Ranger has screws that hold the lid lift handle on, and to the underside of that I used one of the screws to hold one of those U shaped cable plastic clamps that holds a hefty O ring; which in turn holds my culling floats.
My lids hinges are bolted on and what I did was extend a piece of copper wire from one end bolt to the other end bolt on 1 lid. I attached the copper wire onto a small battery post crimp connectors and secured it with the lid nuts. I open the culls and slide them behind the wire( the floats hang down). They are easy to get to and dry quickly.
Enjoying life in Southern Illinois
Command™ Cord Bundlers
under $6 for 2
Can't take credit for this 1, but a fellow BBCer can. Been using these for almost 2 years now.
08 - CHARGER 496 / SUZUKI 250 SS
I have screws on the led latches inside so I backed one out and mounted this to the lid latch where you see all the small clips in this photo. I used the small clips on the float side of the cull tags and they make it much easier to clip the fish & tags onto my culling beam when needed
https://www.lowes.com/pd/Nite-Ize-S-...nless/50150178
This stuff:
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
Cut a 2" piece, 3M extra strong double sided taped it to livewell lid. Drilled 2 holes in it to hold my tags. Been there for a while, hasn't budged and keeps the tags right where I put them. Cheap and easy. Mounted the rest on the bow storage lid for spinner baits.
Plastic clear corner bead drill some holes use 3 m or silicone to the lid. I have had mine going on three years. It is real cheap at Home Depot or menards
I just put a long zip tie through the holes at the top of the divider and clip them on that.
I drilled holes in a piece of aluminum angle and used 3M 30# tape to attach it to my livewell lid. Been there for 2 seasons no problem.
Ditto, emeraldkitty.... works well for spinner baits, when put on the inside of storage lids also.
2001 Ranger Comanche 520DVX
Lowrance HDS Live Electronics
Ghost Trolling Motor
250 Pro XS Mercury
Detwiler Hydraulic 4" jackplate
3" below pad, 40 psi water at speed
26P Fury, 2 solid vent plugs
6000 rpm @ 70 mph GPS, Tournament load
I cut a piece of aluminum a 90* I had hanging around and double sided it to my live well lid and drilled holes in it holds all my cull tags, been in there for over 3 yrs no problem
1990 374V Ranger Still kickin' bass after all these years
I never catch enough to cull lol
This is a little different but works for me. The cull tags are held on an easy view lure hanger and my bump board is stored behind the Starboard seat so everything is within reach when I need to cull. My weigh scale is stored inside the coin box.
I try to drive as if my 16 year old Grandson is following me
Speak as if he is listening and act as if he is watching