My 201 with a Evinrude 250 is really slow out of the hole. Tonight during our tournament it seemed to take 15-20 seconds to break over with two guys and one livewell full of water. Motor was rebuilt last fall but just seems to lack the umph to get up. Other guys with 200s just seem to hit the throttle and go.
Prop is a Raker 14.5x28 set at 3 1/4" inches below pad per the instructions on this page. Wide open I'm hitting about 5500 rpm and a speed of 73 solo (seems like I'm lacking there also)
I seem to get a lot of blow out when running. I have tried lowering the motor to get more bite but that doesn't do much and if I raise it it blows out more. I do notice that there are some knicks in the blades on the prop.
Anyone have suggestions? New prop in a different size, get current prop fixed with more cup?