Results 1 to 2 of 2
  1. #1
    Member
    Join Date
    Apr 2015
    Location
    Fayetteville NC
    Posts
    1

    2005 Ranger 185VS Recessed Trolling Motor Tray Install Help!!?!!?!!!?!!?!?

    I never get on here for much. I know you guys are the guru's. I've bought a fiberglass tray that's made very sturdy from a fiberglass shop in Tennessee. Awesome product. It came with a template. When i got ready to cut it out, I then realized that I was going to be cutting into my front storage compartment. Also the drain on the pan is at the back, so I need to put a 90 turn on it to send it back to the front drain.

    So I'm looking for advice, pictures, any kind of help to complete this. Mainly on what to do about the back wall of my front storage and the Drain but any help would be great!

  2. Member ribbit's Avatar
    Join Date
    Feb 2011
    Location
    san diego,ca
    Posts
    169
    #2
    I did this a few years ago. Same boat. Your tray will be partially into your center storage compartment. This requires you to cut out part of the wall where the pan will sit. Be prepped to dig out lots of foam. Drill a new drain hole in the rear of your compartment (towards the bow) feed drain into that hole. It will drain into the bilge area.

Tags for this Thread