I just purchased 2 helix g2n di units for the bow. And 1 helix 10 g2n mega si and 1 helix 9 2gn mega si for console. I have the Ultrexx tm and 360. I want 2 units in front to run off one transducer and I want 2 units at console to run off 1 transducer but I want them all to share mapping if possible. How do I accomplish this? Thank you so much.
Can't share mapping with Helix units. Would need map card for each unit. Only ONIX and SOLIX are capable of that.
Wes
Helix 10 MSI+,MDI+,Ultrex IPilot
2023 Phoenix 818
Never assume there's a tomorrow
I meant share waypoints...sorry
You can share waypoints...no problem.
Wes
Helix 10 MSI+,MDI+,Ultrex IPilot
2023 Phoenix 818
Never assume there's a tomorrow
If the Ultrex is the iPilot LINK version:
Need two AS ETH 5PXG Ethernett switches, four AS EC QDE Ethernet adapters, and five Ethernet cables.
The LINK and 360 come with 20' Ethernet cables.
One Ethernet cable connects the two Ethernet switches together and each device connects to the switches.
If the Ultrex not the LINK version, you only need one Ethernet switch and four Ethernet cables.
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
Ultrexx is the link version. Thank you
Last edited by winkin20; 04-27-2017 at 08:58 PM.
Reply With Quote